Filter
Top Products
www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
Overview
Hardware Installation
1. Make sure the computer is OFF.
2. Insert the controller into a PCIe 8X or 16X slot.
3. If desired, connect the ACT LEDs, anode to a 3.3V pin,
cathode to the signal pin. For standard LEDs, use a 120-150 Ohm
load resistor in series.
J7 Fan
pin header
heat sink
J6 LED pin header
Port 0-3
Port 4-7
Port 7
Fault
Port 6
Fault
Port 5
Fault
Port 4
Fault
Port 7
ACT
Port 6
ACT
Port 5
ACT
Port 4
ACT
3.3
V
3.3 V Port 3
Fault
Port 2
Fault
Port 1
Fault
Port 0
Fault
Port 3
Fault
Port 2
Fault
Port 1
Fault
Port 0
Fault
GND