Filter
Top Products
www.addonics.com
Phone: 408-573-8580
Fax: 408-573-8588
Email: http://www.addonics.com/sales/query/
CONTACT US
1. Read the firmware update for important changes to the unit's operation
or the update procedure. If a firmware release note contradicts these
instructions, follow the release notes instead.
2. Insert the CipherUSB with a storage device. The CipherUSB will not
respond unless a storage device is attached to it. 3. Run the
CipherUSB.exe program. If the CipherUSB unit has not been
initialized with a password, the Update Firmware tab will not appear.
Initialize the unit with a password, unplug it, plug it back in, then select
the Update Firmware tab.
4. Be sure the DX Information section shows AES Length is 256 and
ECB mode is selected for the CAUF1W, CAUF1W-2, CAUF1M-2 or
CAUF1M. CBC mode for the CAUF2W, CAUF2W-2, CAUF2M,
CAUF2M-2.
5. In the Update new firmware section, click the Firmware button.
Change the file type to “BinaryFile(*.256) if neces sary, then browse to
the folder containing the new firmware and open it.
6. Click the Start Programming button. A dialog will shortly appear
instructing you to remove the CipherUSB and reinsert it. After
removing and reinserting the device, the firm ware update will be
completed.
NOTE: The CipherUSB may or may not need to be initialized with the password
again. If a storage device using the existing password is connected when the
CipherUSB is reinserted and the file system appears intact, the password has been
retained. Otherwise it may be necessary to set the password again.