Filter
Top Products
Step 4
Turn the Diamond enclosure over with
the hard drive mounting holes facing
up. Use the included flat head screws
to secure the hard drive onto the
bottom of the enclosure and turn in
the screw to the “LOCK” position.
Powering On the Mobile Rack:
Note: Be sure the Diamond cipher key is inserted into the drive enclosure prior
to turning on the power of the drive cradle. The hard drive will not be
detected by the computer if the power to the drive cradle is turned on
without the Cipher key. Under such condition, the power on the drive
cradle will have to be turned off and turned back on again with the
Cipher key already inserted into the drive enclosure in order to detect
the hard drive.
Power Switch:
To power on the enclosure, use the key provided to turn the locking mechanism
on the drive cradle into the Lock position. When the switch is turned on, the
green LED located on the left side of the drive cradle would light up to indicate
power. The encryption key LED will also light up. The amber LED will blink if
there is drive activity.
Note: Brand new hard drive must be partitioned and formatted first before a
drive letter is assigned by the OS. When a hard drive with data on it is
formatted with the Diamond cipher all the data will be erased.
Once the drive is detected by the system OS, the Diamond cipher key
may be removed from the drive enclosure. The encryption key LED will
turn off but the Diamond Cipher hard drive will continue operating
normally (encrypting) till it is removed from the system or powered off.
Cable Connections
Model: DCMR256I
Power: Using the 4-pin floppy connector of the Y-cable, connect it to the floppy-
type power connector on the converter. To provide power for the y-cable,
connect it to one of your desktop's 4-pin molex cable.
Data: Connect the IDE ribbon cable to the 40-pin IDE connector of the SATA to
IDE converter board and to the IDE channel of your motherboard.
LED cable: No need to connect. By factory default, LED signal would come from
the hard drive.
Powering On Drive Cradle:
To power on the drive cradle, slide in the Diamond cartridge and using the key
(supplied), turn the cradle lock located at the front of the cradle to the LOCK
position. This will provide power as indicated by the green LED lighting up and
secure the cartridge.
Note: This configuration would not support hot-swap.
Power & Drive
Activity LED
Key Lock Switch
IDE-SATA Converter
40-pin IDE ribbon
cable