Filter
Top Products
ADDONICS TECHNOLOGIES
Model: RT54S2HMEU
4. While holding the RAID setting button, turn on the HPM and SATA
hard drives and continue to hold button for at least 5 seconds.
Note: The onboard LED's for the eSATA and USB will start blinking
while holding down the raid setting button. Once the raid
setting button is released, the PM Health LED will blink 4-6
times.
If the PM Health LED stops blinking, the raid set is set
correctly. If the PM Health LED lights up as solid green, it is a
bad setup. You need to repeat setting up the raid again.
Instruction for Special RAID Modes:
BIG 2 - 2 Drives Spanned
o Note: Do not connect more than 2 SATA drives to the hardware port
multiplier. Doing so will hang the system when you configure the
raid.
o For SATA drives with different capacities, the hardware port
multiplier will use the smallest drive capacity of the 2 drives
connected to create the total partition size.
FAST 2 - 2 Drives Striped
o Note: Do not connect more than 2 SATA drives to the hardware port
multiplier. Doing so will hang the system when you configure the
raid.
Verify RAID Setting on the HPM
Note: Disconnect the HPM from host when verifying the RAID setting.
It is assumed that you have already connected the SATA drives and set
up the raid mode when verifying the raid setting.
1. Turn on the power for RAID V.
2. Push the RAID setting button with the tool provided. Using the
table below, verify if the LEDs are lighting up. The selected
LEDs will light up for 2 seconds followed by a blink and cycles
back.
RAID Mode
LEDs
BIG 2
LEDs 1, 2 & 3 all OFF
BIG 4
1 ON, 2 & 3 OFF
FAST 2
3 ON, 1 & 2 OFF
FAST 4
2 ON, 1 & 3 OFF
SAFE FAST
1 & 3 ON, 2 OFF
SAFE 2
1 & 2 ON, 3 OFF
RAID 5
2 & 3 ON, 1 OFF
RAID 5 + S
1, 2 & 3 all ON
LED number is per HPM mounted
TECHNICAL SUPPORT
Phone: 408-453-6212
Hours: 8:30 am - 6:00 pm PST
Email: http://www.addonics.com/support/query/