Filter
Top Products
Chapter 6. Configuration
61200051L1-1D ISU 2x64 Dual Port ISDN Service Unit User Manual 57
Figure 6-22
Protocol BONDING, Mode 1 Menu Tree
The timers are defined as follows:
TXINIT
This option specifies the length of time the originating endpoint
attempts to detect BONDING negotiation pattern from the
answering endpoint before determining the BONDING call has
failed. In general, this timer value should be left at the factory
default setting of 10 seconds. Select from values of 1, 2, 5, 10
(default), 20, 50, 100, and 200 seconds.
TXFA
This option specifies the length of time both endpoints attempt to
detect the BONDING frame pattern when a call is connected
before determining the BONDING call has failed. This timer
value should be left at the factory default setting of 10 seconds.
However, when interoperating with other manufacturers’
BONDING equipment it may be necessary to lengthen this timer
to match TXADD01. Values of 1, 2, 5, 10 (default), 20, 50, 100, and
200 seconds may be selected.
TXADD01
This option specifies the length of time both endpoints wait for
the additional call to be connected at the end of negotiation
before determining the BONDING call has failed. The factory
default setting of 20 seconds is sufficient for most calls to go
through, although when dialing overseas it may be necessary to
lengthen this timer to allow for slower call routing. Values of 1, 2,
5, 10, 20, 50 (default), 100, and 200 seconds may be selected.
3=CONFIG
1=Netw. options
2=DTE options
3=Protocol
4=Quick setup
5=Security
6=Remote Config
1=Clear Channel
2=BONDING mode 1
3=V.120
4=V.110
5=DSU 57.6 ASYNC
6=T-LINK
7=SAP
8=FALLBACK
9=PPP async-sync
1=TXINIT
2=TXFA
3=TXADD01
4=TXDEQ
5=TANULL
6=TCID
7= Async. Rev.