Filter
Top Products
Appendix C: Status Buffer Messages
100
ISU 2x64 Dual Port ISDN Service Unit User Manual 61200051L1-1D
Bad DTE baud
The DTE bit rate does not match a valid bit rate for the protocol se-
lected.
Bad DTE bps
Bonding negotiation determined the chosen DTE bit rate is in-
valid.
BAD_INFO_ELEM
Call control error.
Bad phone number
ISU 2x64 attempted to call an invalid phone number.
Bad TLK Version
Invalid TLINK parameters found during end-to-end negotiations.
Baud Rate
ISU 2x64 does not support the negotiated TLINK baud rate.
BEAR_CAP_NOT_AVAIL
The bearer channel requested by the user is not available.
Bearer mode
Incoming call is not of a type the ISU 2x64 can accept.
Bearer info mode
Incoming call information transfer capability is not known.
BONDING (+/- XXX)
The amount of bytes of corrected delay between the B2 and B1
bearer channels (XXX can range from -8000 to +8128 bytes ).
BPS mismatch
Bonding negotiation found a bit rate mismatch.
Break to AT cmd
User issued a break-in request (+++).
Break ignored
User issued an extra break-in request.