Filter
Top Products
Wiring Descriptions
61180043L2-5D 7
Alternate Mounting
Two alternate mounting methods include mounting directly to a wall using customer supplied
wood screws, or to a 16-gauge steel bracket (P/N 3265555) that mounts in the cabinet.
Bracket mount location is normally at the battery position when batteries are mounted
external to the cabinet. The bracket has threaded mounting holes that align to the PS/BC
mounting tabs. The PS/BC can be mounted to either side of the bracket, or two PS/BCs can
be mounted, one on each side. Openings in the bracket allow for wire management. Hardware
for bracket mounting is purchased from ADTRAN. When determining the alternate mounting
location, ensure supplied cabling reaches the designated termination point including dressing
and lacing.
Provisioning
Aside from various PS/BC and battery mounting and wiring configurations, there are no end
user controls, adjustments, or options associated with the PS/BC.
WIRING DESCRIPTIONS
The wiring required for the single PS/BC and dual battery configuration is included.
CAUTION
All grounds must terminate at a known ground location. Check
metal-to-metal contact on all ground connections. Do not stack or
combine grounds. Ensure ground circuit continuity.
Ground
A ground post adjacent to the PS/BC fuse is available for frame ground.
WARNING
Do not connect AC power or make battery connections until all
other connections have been made for the designated installation
and protective covers and shields have been installed.
120 VAC Power Input
AC input is through a 10-foot wire with a three prong grounded plug on the end. The line is
hardwired to the PS/BC.
NOTE
In the optional two PS/BC configuration, a fully redundant system
requires that each PS/BC have an independent AC source.