Open as PDF
CLEI: T1L3X5BA_ _
STATUS ● RED Alarm on the H2TU-C loop, H2R loop, DSX or DS1 interface.
✷ FLASHING Signal Quality of 0 or No Sync on the loop.
● AMBER Loopbacks active.
✷ FLASHING In-band loopbacks armed.
● GREEN Functioning properly.
✷ FLASHING ES, SES, or BPV detected at either DSX or DS1 interface.
RS-232 DB-9 CONNECTOR
■ Used to access the HDSL2 utilities menu tree via VT100 emulation software such as
Terminal, Hyper Terminal – Private Edition, and ProComm Plus.
■ There are two types of terminal emulation modes, Manual and Real-Time. To toggle
between the two modes, type “CTRL” and “T.” To update the screens while in Manual
Mode, press the space bar 3 times. Real-Time Update Mode is the default.
■ Provision terminal port as follows:
Data Rate — 1.2 kbps to 19.2 kbps
Asynchronous Data Format — eight data bits, no parity (none), one stop bit, and no
■ Hardware Flow Control – disabled.
■ When using a PC with terminal software, be sure to disable any power saving programs.
This product is intended to be installed in an enclosure with an Installation Code (IC)
of “B” or “E” and in Restricted Access Locations only.
Warranty for Carrier Networks products manufactured by ADTRAN and supplied under
Buyer’s order for use in the U.S. is ten (10) years. For a complete faxback copy of
ADTRAN’s U.S. and Canada Carrier Networks Equipment Warranty: (877) 457-5007,
CIRCUIT BOARD 6-POSITION DIP SWITCH – SW1
Provisions the unit. (Default settings are in bold.)
■ Selects line coding to AMI or B8ZS
■ Selects T1-framing to FRAMED or UNFRAMED
■ Selects T1-framing to SF or ESF
■ ENABLES or DISABLES the NIU loopback
■ ENABLES or DISABLES the loopback timeout
■ ENABLES or DISABLES the shelf alarm
UNFRAMED operation ignores the setting of SW1-3
Default timeout setting is 20 minutes when loopback timeout is ENABLED
CIRCUIT BOARD 5-POSITION ROTARY SWITCH – SW2
Sets the DSX-1 Line Build Out (LBO). (Default settings are in bold.)
■ 0 — 0-133 feet of LBO
■ 133 — 133-266 feet of LBO
■ 266 — 266-399 feet of LBO
■ 399 — 399-533 feet of LBO
■ 533 — 533-655 feet of LBO
Code Input Output
Installation Code (IC) A —
Telecommunication Code (TC) — X
Power Code (PC) F C
C A U T I O N
C A U T I O N
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.
For a complete Installation and Maintenance faxback document: (877) 457-5007, Document #695. Please have your fax number available.