ADTRAN none Network Card User Manual


  Open as PDF
of 2
 
NetVanta Serial Dial Backup Interface Module (DIM) P/N 1200886L1
For more detailed documentation, visit us online at www.adtran.com.
Quick Start Guide
®
Quick Start Guide, 61200886L1-13B, July 2006 Technical Support 1-888-4ADTRAN (1-888-423-8726) Copyright © 2006 ADTRAN, All Rights Reserved
SERIAL DIM COMMANDS
alias <“text”>
Populates the ifAlias OID (Interface Table MIB of RFC2863) for all physical
and virtual interfaces when using SNMP management station.
caller-id override [always <number> | if-no-CID <number>]
Configures the unit to replace caller ID information with a user-specified
number. Use the no form of this command to disable any caller ID overrides.
always <number> Always forces replacement of the incoming
caller ID number with the number given.
if-no-CID <number> Replaces the incoming caller ID number with
the number given only if there is no caller ID
information available for the incoming call.
description <text>
Identifies the specified interface, both physical and virtual (for example,
circuit ID, contact information, etc.), using up to 80 alphanumeric characters.
dialin
Enables the modem for remote console dial-in, disabling the use of the
modem for dial-backup.
init-string <string>
Specifies an initialization string using standard AT commands. Use the no
form of this command to return to the default initialization string.
<string> Specifies an initialization string using standard
AT commands. This string must start with AT
and cannot contain spaces. The default string
is ate0q0v1x4\n0.
shutdown
Disables the interface (both physical and virtual) so that no data will be
passed through. Use the no version of this command to turn on the interface
and allow it to pass data.
 previous