Filter
Top Products
MIC-3081 User Manual --- Page 9
chassis:
To install a card:
1. Hold the card vertically. Be sure that the card is oriented correctly.
The components of the card should be pointing to the right-hand side.
2. Be sure that the handles of the card are not latched. Release the handles if they
are latched. Handles from different vendors may have different latch designs.
Caution: Keep your fingers away from the latch hinges to prevent your fingers from
getting pinched.
3. Insert the card into the chassis by sliding the upper and lower edges of the card
into the card guides.
4. Push the card into the slot gently by sliding the card along the card guide until the
handles meet the rectangular holes of the cross rails. 1 2
Figure 2-3: Installing a card into the chassis
Note: If the card is correctly positioned and has been slid all the way into the chassis,
the handles should match the rectangular holes. If not, remove the card from the
card guide and repeat step 3 again. Do not try to install a card by forcing it into the
chassis.
5. Pull the upper handle down and lift the lower handle up to push the card into
place.
6. Secure the card by locking the handles into place.