Advantech PPC-140 Personal Computer User Manual


 
Chapter 4 Hardware Installation and Upgrading
39
10.Connect the power cable of the CPU fan to the 2-pin connector (J12).
11. After changing the CPU, you must set jumpers, including those for the
PCI bus clock (JP8), system/PCI clock (JP11), frequency ratio (JP14),
and voltage (JP13). (See Section 5.2.)
12.To remove the CPU, pull the lever out to the side a little and raise it as
far as it will go. Lift out the CPU chip.
NOTE! When you install a new CPU, be sure to adjust the
board jumper settings. Improper settings may damage
the CPU. (See Chapter 5 for jumper settings.)
Figure 4-3: Installing the CPU
CPU fan
CPU
Heat sink
Lever
Socket 7
Heat sink
clip