Filter
Top Products
UNO-1170 User Manual 28
6. Turn the hard drive bracket and align with the screw hole on the
rear cover. Use the four screws taken from step 4 and screw the
bracket and the rear cover tight.
7. Connect the other end of SATA cable on the board which the arrow
indicated in below picture.
8. Screw the rear cover and the six screws.
9. For user who tried to plug other SATA device, please note the
UNO-1150E SATA power connector doesn't support 12V power.
Note: There are switch setting about SATA hard drive below,
please refer to the section A.9 for detail. The hard drive
might not work correctly if the switch setting is incorrect