Filter
Top Products
Step 2 Click Next to start the configuration.
Step 3 Connect one end of a network cable to a LAN port (1~5) of the AP
and connect the other end to a LAN port of the router. Power on the AP.
Step 4 Make sure the LEDs of POWER, WLAN and the LAN port that is
connected to the Router are lit. If not, try the above steps again.
LED Indicators:
Step 5 Enter the AP’s password to log in to the AP. The default password is
“admin”. It is recommended to change the AP’s password to protect it from
being accessed by other users. If you do not wish to change the current
password, you can leave New Password and Confirm New Password blank.
Click Log in.
LED
Light
Status
Description
POWER On Router is powered on.
On WPS setup is in progress.
Off Wireless network is switched off.
WLAN
Flashing
Wireless network is ready and WPS setup is
not in progress.
On LAN port is connected.
Off LAN port is not connected.
LAN 1~5
Flashing LAN port is transferring or receiving data.