Filter
Top Products
6
Installation
Installation the 10/100Mbps PCI bus Fast Ethernet
Adapter requires Hardware installation first, then
BIOS and Software installation.
Step 1, Hardware Installation
1. Switch off the computer, unplug the power
cord, and remove the computer’s cover.
2. Select an unused PCI slot and remove its
protective bracket.
3. Carefully insert the Adapter and press until all
the edge connectors are firmly seated inside
the slot. Then, screw the Adapter’s bracket
securely into the PC’s chassis.
4. Attach the Wake-On-LAN cable (optional, for
PCI 2.1 motherboard). If you require
Wake-On-LAN capability, attach one end of
the 3-pin Wake-On-LAN cable to the
connector on the top edge of the Adapter, and
the other end to the “WOL” connector on the
computer’s motherboard. Refer to your
computer’s installation manual to locate this
connector.
5. Install the bracket screw, which secures the
Adapter to the computer’s chassis.
6. Replace the computer’s cover and connect the
network cable to the newly installed network
Adapter. Reconnect the computer’s power
cord and plug it into the power outlet.