Alcatel-Lucent 1511 BA Network Card User Manual


  Open as PDF
of 4
 
Alcatel-Lucent 1511 BA | 2 Mb/s 30-Channel Primary Rate Multiplexer2
Architecture
ThePCMController(PCMC2)interfaces
the users and the E1 aggregate side.
The controller connects the analog,
data or N x 64 kb/s data terminal
channels of the tributary boards,
orthePCMC2inslavemode,tothe
2,048kb/sG.703/G.704aggregate
via an internal serial bus.
ThePCMC2provides:
• Atransmission/switchinginterface
andHDB3tobinarycoding/decod-
ing, retiming, frame alignment and
supervision, cyclic redundancy check
#4(CRC4)generation/monitoring,
channelmapping,CAS,alarmtreat-
ment and test facilities
• Anasynchronousserialcommuni-
cation channel to a central alarm
supervising unit through which the
user can communicate about equip-
ment configuration, status and alarms
• Twoserialchannelsforembedded
operationchannel(EOC).These
channels can be used for transport
of network management protocols
between the network element and
its centralized management units.
PowerunitboardsforDC/DCandAC/
DCconversionareprovidedforeach
subrack assembly and can be dupli-
cated for redundancy.
Applications
POTS Subscriber Multiplexer
The POTS subscriber multiplexer is used
in the subscriber network and allows a
exiblemixofvoiceanddatainter-
faces. Adaptation of the signaling to
the customer’s requirements can be
done easily.
ISDN-BRI
The Alcatel-Lucent 1511 BA can be
usedforISDN-BRIapplications.Both
2-and4-wire(Uwithlinecode2B1Q
and S0/I.430) interfaces are available.
Each interface uses three timeslots
(2B+D16/M)onthe2Mb/sG.703link.
Hot Line
Hot Line is a bi-directional application,
with a centralized battery set, where
one subscriber hooks off and the other
is called without dialing. It uses the
same board as the POTS application.
This board’s lines can be programmed
either as a POTS or Hot Line.
Ringdown
ManualRingdown(MRD)isanAlcatel-
Lucent 1511 BA application that permits
the connection of two local battery
(LB) telephone sets or the connection
of a local battery telephone set to a
central switch board. This application
is widely used by stock market brokers.
It requires the use of a special ring-
down board.
Direct Dialing In
The Alcatel-Lucent 1511 BA provides
directdialingin(DDI),afeaturewhereby
the dialing information is sent directly
from the PSTN to the PABX, which
then sets up the connection to the
PABX subscriber.
Data Multiplexer
The Alcatel-Lucent 1511 BA can be used
as a data multiplexer. The possible data
tributaries are:
• 64kb/sG.703co-directional—with
optionalE&Msignaling
• 64kb/sG.703contra-directional
• 2Mb/sandNx64kb/sG.703/G.704.
(fractional E1)
• Lowspeed:75b/sto64kb/sforV.36,
V.35,V.28andX.21
• Nx64kb/s(N=1to31);interfaces:
V.35,V.36andX.21
Remote Data Unit
The Alcatel-Lucent 1511 BA provides an
integrated digital interface to remote
dataunits(RDUs).TheRDUsareprovided
with one or two of the following inter-
facesinanycombination:V.35,V.36,X.21
andV.24/V.28upto128kb/s,analog
and64kb/sG.703co-directionalinter-
faces. Performance monitoring on the
RDUisforeseenonthedigitallink.
High Quality Audio Tributaries
The Alcatel-Lucent 1511 BA can per-
form unidirectional audio transmission.
ThisaudioboardusesMPEG-215kHz
sampling.
2/4-Wire Audio Interface
Connectionbetweenanalogmodems
or PABX ports for tie-line connections
canbeachievedwiththe2/4-wire
audioboard.Variantswithorwithout
E&Mwiresareavailable.
Conference Bridge
Two types of conferences are possible:
• Master-slaveconference:Onepartic-
ipant is considered the “master” and
all others are considered “slaves.”
Onemasterwithupto29slavesis
possible.
• Fullconference:Thistypeofconfer-
ence is used when all participants
need to share information equally.
Every participant receives informa-
tion from all other participants but
himself or herself.
These two types of conferences can be
used for voice, data or signaling.
The conference bridge is a simple and
useful board in networks with super-
visory control and data acquisition
(SCADA)and/oraudiodispatching
requirements.
Dry Relay Contacts
This board has a number of detectors
for dry relay contacts. It is used for
collecting alarm indications of col-
located equipment and enables the
visualization of alarm states on the
same craft terminal or server as that
being used for the multiplexer
functions.
Integrated Optical Transport
BoardsforopticalPDHtransportof
4 or 16 E1 streams can be plugged into
the Alcatel-Lucent 1511 BA subrack and
managed by the same management
tools.SeetheAlcatel-Lucent1521FL
andtheAlcatel-Lucent1531FL.
 previous next