Filter
Top Products
Patch 54266-02 3
Patch 54266-02
C613-10417-00 Rev B
If OSPF was configured using the command set ospf dyninterface=stub, to
advertise dynamic interfaces such as PPPoE interfaces as stub links, the
links were not being advertised as expected. This issue has been resolved.
When an IPSEC policy is used on a PPP link with iprequest=on, when the
PPP link goes down and IPSEC has traffic to transmit, IPSEC repeatedly
attempts to activate the PPP link again. The frequency of the reactivation
attempts has been reduced.
In certain situations, if a DHCP client used a DHCP relay agent to request
IP addresses from the router acting as the DHCP server on a different
subnet, it was not be able to renew the IP address allocated to it. This issue
has been resolved.
IGMP entries were sometimes changed to static entries rather than being
deleted when IGMP leaves were received. This issue has been resolved.
The "number of hits" counter in firewall's application rules was not
incremented correctly. This issue has been resolved.
Particular IP packets (unicast destination IP, but multicast destination MAC)
could result in a memory leak, which in some cases could cause the device to
stop responding to the command line. This issue has been resolved.
The enable switch learning command would fail if 802.1X port
authentication was enabled on any of the switch ports. This issue has been
resolved.
The router was accepting network RIP packets from foreign subnets. This
issue has been resolved.
The router could reboot when a user changed the Rendezvous Point
Candidate (RPC) priority in the PIM6 module. This issue has been resolved.
PCR: 40419 Module: OSPF, IPG Level: 2
PCR: 40442 Module: IPSEC Level: 2
PCR: 40446 Module: DHCP Level: 2
PCR: 40450 Module: IPG Level: 2
PCR: 40451 Module: FIREWALL Level: 2
PCR: 40453 Module: PIM Level: 2
PCR: 40456 Module: IPG Level: 2
PCR: 40458 Module: IPG Level: 2
PCR: 40465 Module: PIM6, PIM4 Level: 2