Filter
Top Products
3
Chapter 2
Installation
Verifying Package
Contents
Make sure your package contains the following items.
!
One AT-FH800 Series Fast Ethernet Hub
!
Four rubber foot pads
!
Stack cable
!
Rack mount bracket kit
!
AC power cord
!
This installation guide
!
Warranty card
Pre-Installation
Requirements
Prior to installing your hub, make sure you observe the following cabling and
installation environment requirements. The hub can be placed directly on your
desktop or mounted in a rack.
!
Do not plug a phone jack connector into any RJ-45 port. This may damage
the hub. Use only twisted-pair cables with RJ-45 connectors that conform
with FCC standards.
!
Make sure each twisted-pair cable does not exceed 100 meters (328 feet).
!
Allied Telesyn recommends using Category 5 cable for all network
connections to avoid any confusion or inconvenience in the future when
you upgrade attached devices to Fast Ethernet.
!
Power requirements: 100 to 240 VAC
±
10% at 50 to 60 Hz
±
3Hz. The
hub's power supply automatically adjusts to the input voltage level.
!
The hub should be located in a cool, dry place, with at least 10 centimeters
(4 inches) of space at the front and back for ventilation.
!
Place the hub out of direct sunlight, and away from heat sources or areas
with a high amount of electromagnetic interference.
!
If you intend to mount the hub in a rack, make sure you have all the
necessary mounting screws, brackets, bolts and nuts, and the right tools.
!
Check if network cables and connectors needed for installation are
available.