Allied Telesis AT-9000 Switch User Manual


  Open as PDF
of 12
 
PN 613-001447 Rev A 1
4
AlliedWare Plus™ Version 2.1.2
AT-9000 Layer 2-4 Gigabit Ethernet EcoSwitches
Software Release Notes
Please read this document before you begin to use the management software. The document
has the following sections:
“Supported Platforms” on page 1
“What’s New in Version 2.1.2” on page 2
“Introduction to Upgrading the Switch” on page 2
“Upgrading the AT-9000 Switch to AlliedWare Plus Version 2.1.2 from Version 2.1.1” on
page 3
“Troubleshooting the Upgrade Procedure” on page 6
“Operational Notes” on page 6
“Resolved Issues” on page 7
“Known Issues” on page 8
“Changes to the AlliedWare Plus Command Line User’s Guide” on page 9
“Contacting Allied Telesis” on page 12
Caution:
The software described in this document contains certain cryptographic functionality and its
export is restricted by U.S. law. As of this writing, it has been submitted for review as a “retail
encryption item” in accordance with the Export Administration Regulations, 15 C.F.R. Part 730-
772, promulgated by the U.S. Department of Commerce, and conditionally may be exported in
accordance with the pertinent terms of License Exception ENC (described in 15 C.F.R. Part
740.17). In no case may it be exported to Cuba, Iran, Iraq, Libya, North Korea, Sudan, or Syria. If
you wish to transfer this software outside the United States or Canada, please contact your local
Allied Telesis sales representative for current information on this product’s export status.
Supported Platforms
Version 2.1.2 of the AlliedWare Plus™ Management Software is supported on these switches:
AT-9000/28
AT-9000/28SP
AT-9000/52
This version supports the following SFP modules:
AT-SPTX (Supported only at a speed of 1G.)
next