Filter
Top Products
10 Software Maintenance Release Note
Version 89275-02 for Software Release 2.7.5
C613-10458-00 REV A
Implementation of 2 new commands:
enable bgp backoff
disable bgp backoff
Alteration of the functionality of the "set bgp backoff " command to allow a
"low" parameter
E.g. "set bgp backoff low=x" where "x" is between 15 and 99.
Addition of a new sub-command to the "show bgp memlimit" command.
This now contains the parameter "bgp".
E.g "show bgp memlimit bgp"
Functionality has been added to enable or disable GBIC / SFP ports
electrically or logically, by issuing the respective commands. Disabling
ports electrically would mean that the optics for the respective ports can be
turned ON or OFF. Logical disabling would indicate that the optics
(physical link), remains ON while the ports are disabled at a logical level.
Implementation of a new command parameter:
link = enable/disable
E.g. “ena swi port = x link = enable”
/* Show the current status of a GBIC port on the switch
*/
Manager sh swi po=13
Switch Port Information
-------------------------------------------------------
Port ..........................13
Description .................-
Status ......................ENABLED
Link State ..................Up
/* Do a Logical disable */
Manager disable swi po=13
Info (1087003): Operation successful.
/* Show the status of the switch after the electrical
disable */
Manager sh swi po=13
Switch Port Information
-------------------------------------------------------
CR00009993 Module: SWITCH