Filter
Top Products
How to Start an AT-GS950/24 WEB Management Session
32
Figure 14. Factory Default Reset/Reboot Page
3. Go to the lower part of the page to the Reboot section.
4. In the Reboot Type field, select Normal from the pull-down menu.
When the switch is rebooted with this selection, all configuration
parameters that are saved in flash memory are loaded into the switch’s
active memory.
Note
Two additional options are available in the Reboot Type field. The
procedures for these options are described in "Configure Factory
Default Values".
5. Click Apply.
The switch immediately begins to reload the AT-S109 Management
software and configuration parameters. This process takes
approximately two minutes to complete. You can not manage the
device during the reboot. After the reboot is finished, you can log in
again if you want to continue to manage the switch.
Configure
Factory Default
Values
This procedure returns all AT-S109 Management software parameters to
their factory default values and deletes all tagged and port-based VLANs
on the switch.
Note
The AT-S109 Management software default values are listed in the
AT-GS950 Web User Guide..