Filter
Top Products
AT-GS950/48PS Switch Web Interface User’s Guide
79
this port receives root path cost information that is greater than
the root port's path cost and less than any other port's received
information, then this port becomes the designated port.
Backup - Any operational Bridge Port that is not a Root or
Designated Port is a Backup Port if the Bridge is the Designated
Bridge for the attached LAN.
Alternate - Any operational Bridge Port that is not a Root or
a Designated Port is an Alternate Port if that Bridge is not the
Designated Bridge for the attached LAN.
Admin/OperEdge - Indicates if a port is connected to an edge
device in the network topology or not.
True - The port is connected to an edge device and the port will
always be in a forwarding state.
False - The port is not connected to an edge device.
Admin/OperPtoP - Indicates if the port is connected to another
network device (point-to-point) in the network topology.
True - The port is connected to a network device in the network
topology.
False - The port is not connected to a network device in the
network topology.
Migration - Indicates if the port is configured to accept RSTP and
STP BPDUs
5. Click Apply for the port you are configuring.
6. To configure all of the ports to the same settings, in the All row,
configure one, two, or all of the following settings: Admin/OperEdge,
Admin/OperPtoP, and Migration.
7. Click Apply.
8. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.