Filter
Top Products
AT-MC606 VDSL Network Extender Installation Guide
43
LINK/ACT LED - 10Base-T/100BaseTX Ethernet Port
Verify that the LINK/ACT LED for the 10Base-T/100BaseTX Ethernet port
is ON. If a LINK/ACT LED is OFF, do the following:
Verify that the end node connected to the port is powered ON and is
operating properly.
Check that the twisted pair cable is securely connected to the port on
the AT-MC606 and to the port on the end node.
Make sure that the twisted pair cable does not exceed 100 meters (328
feet).
Verify that you are using the appropriate category of twisted pair cable:
Category 3 or better for 10 Mbps operation, Category 5 and Category
5E for 100 Mbps operation.
Make sure that the operating parameters of the port on the
AT-MC606 are compatible with the end node to which the port is
connected.
LINK LED - Coaxial VDSL LINE Port
Verify that the LINK LED for the coaxial VDSL LINE port is either solid
green, slow blinking green (approximately 1 time/second), or rapidly
blinking green (approximately 6 times/second. If a LINK LED is OFF, do
the following:
Check that the coaxial cable is securely connected to the port on the
AT-MC606 and to the port on the end node.
Verify that the end node connected to the port is powered ON and is
operating properly.
Verify that one of the AT-MC606 modules is configured as the
Subscriber unit and the second AT-MC606 module is configured as the
Provider unit.
It is normal for the coaxial VDSL LINE port LINK LED to blink
approximately 3 times/second when the training or handshake mode
occurs. It is not normal for the training or handshake mode to continue for
more than 1 minute before indicating an idle or link condition. If this
abnormal condition occurs, do the following:
Check that the coaxial cable is securely connected to the port on the
AT-MC606 and to the port on the end node.
Verify that the end node connected to the port is powered ON and is
operating properly.
Verify that one of the AT-MC606 modules is configured as the
Subscriber unit and the second AT-MC606 module is configured as the
Provider unit.