Filter
Top Products
20 Patch Release Note
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
When a Rapieri Series Switch was using layer 3 multicast protocols, IGMP
group members on the upstream interface for the multicast stream would
always be forwarded to, even if they left the group. This issue has been
resolved.
The HTTP proxy server terminated a session when uploading a large file.
This issue has been resolved.
The following issues with IPv6 have been resolved:
• Incorrect default values were set for the PREFERRED and VALID
parameters in the ADD IPV6 PPFEFIX command. The correct default
for PREFERRED is 604800 seconds (7 days), and the correct default for
VALID is 2592000 seconds (30 days).
• The PREFERRED and VALID parameters in the ADD IPV6 PPFEFIX
and SET IPV6 PREFIX commands were accepting values that could
make the preferred life time longer than the valid life time.
• The POISONREVERSE parameter in the ADD IPV6 RIP command was
not added to the automatic configuration.
If IPsec was using PPPoE, the initiator continued to keep the IPsec SA even
if the PPPoE session failed and the ISAKMP Heartbeat timer expired. This
issue has been resolved.
A memory leak occurred in IP or IPV6 if PIM-SM received IGMP or MLD
reports, and there was no Rendezvous Point for the reported group.
The DHCP lease Expiry time showed incorrectly in the SHOW DHCP
CLIENT command when the lease straddled across multiple months and
years. This issue has been resolved.
The allowable UDPPORT range has been changed from 1-5000 to 1-65535 in
the ENABLE ISAKMP command.
The SHOW SWITCH FDB command output was incorrect when using the
Protected VLAN feature. This issue has been resolved.
PCR: 03372 Module: IPG Level: 3
PCR: 03373 Module: HTTP Level: 3
PCR: 03375 Module: IPG Level: 2
PCR: 03379 Module: IPSEC Level: 3
PCR: 03387 Module: PIM, PIM6 Level: 2
PCR: 03388 Module: DHCP Level: 3
PCR: 03393 Module: ISAKMP Level: 3
PCR: 03397 Module: SWI Level: 3