Filter
Top Products
Patch SB251-01 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches 3
Patch SB251-01 for Software Release 2.5.1
C613-10361-00 REV A
• The number of user-specified protocols in the PROTOCOL parameter
has been increased from three to seven.
• The minimum value of the IPXDADDRESS parameter has been
decreased from 10000000 to 00000001.
An issue which sometimes resulted in a broadcast storm within the internal
ports on the SwitchBlade, a reduction in bandwidth, and a loss of pinging
has been resolved.
An issue which caused pings to fail when a control card was inserted in the
left hand slot to act as a slave, has been resolved.
Support has been added to allow for multicasting to any number of
overlapping VLANs up to the maximum number of multicast forwarding
entries.
An issue with pings failing after network host routes disappeared from the
switch due to an IP hashing error has been resolved.
An issue with an interrupt occuring when waiting on the MDIO which
caused the MDIO to read or write incorrect information has been resolved.
Ping would sometimes not work correctly after a 48 line card was extracted,
and after a restart reboot. This issue has been resolved.
Availability
Patches can be downloaded from the Software Updates area of the Allied
Telesyn web site at www.alliedtelesyn.co.nz/support/updates/patches.html
. A
licence or password is not required to use a patch.
PCR: 03006 Module: SWI Network affecting: No
PCR: 3008 Module: SWI Network affecting: No
PCR: 03014 Module: IPG, SWI Network affecting: No
PCR: 03018 Module: SWI Network affecting: No
PCR: 03020 Module: SWI Network affecting: No
PCR: 03021 Module: SWI Network affecting: No