Filter
Top Products
2 Patch Release Note
Patch sr264-03 for Software Release 2.6.4
C613-10407-00 REV C
Some of the issues addressed in this Release Note include a level number. This
number reflects the importance of the issue that has been resolved. The levels
are:
Features in sr264-03
Patch sr264-03 includes all issues resolved and enhancements released in
previous patches for Software Release 2.6.4, and the following enhancements:
While the switch was set with a CIDR interface address, when it received an
ECHO request with a network broadcast destination address for a class C
network, the switch sent the ECHO reply packet. Also, the switch
forwarded the ECHO request packet using a broadcast MAC address. These
issues have been resolved.
When an IP interface is in a down state and VRRP is configured on the
interface, VRRP should be disabled. If it was enabled, VRRP could
transition to "INITIAL" state. This issue has been resolved.
The L3 filter nomatchaction parameter was not applied for some IP traffic
on the switch. This issue has been resolved.
If the ENCO process used to encrypt an ISAKMP packet failed, a switch
reboot could occur. This issue has been resolved.
When a master VRRP router was configured from a boot script, the
transition to the MASTER state occurred before the Layer 2 interface had
been initialised, preventing the gratuitous ARP from being sent. This issue
has been resolved.
Level 1 This issue will cause significant interruption to network services, and
there is no work-around.
Level 2 This issue will cause interruption to network service, however there
is a work-around.
Level 3 This issue will seldom appear, and will cause minor inconvenience.
Level 4 This issue represents a cosmetic change and does not affect network
operation.
PCR: 31225 Module: IPG Level: 3
PCR: 40355 Module: VRRP Level: 2
PCR: 40357 Module: SW56 Level: 2
PCR: 40405 Module: ENCO Level: 2
PCR: 40415 Module: VRRP Level: 2