Allstar Products Group 831E Paper Shredder User Manual


 
Page 1 of 4
P/N 106547 REV D
831E COMMERCIAL
RECEIVER
INSTRUCTIONS
MODELS:
831E
831E MASTER & SLAVE UNITS
READ THIS MANUAL CAREFULLY
BEFORE BEGINNING INSTALLATION
Allstar 831E Commercial Receivers are designed to work with most commercial door operators. The 831E is connected to the
commercial operator in the same manner as a 3-button station and provides open, close and stop functions via radio control. The
receiver is powered from the operator’s 24 VAC transformer. The antenna is removable and may be moved (using coaxial cable) to a
new location for better RF reception. When receivers have to be installed in close proximity to each other (such as Fire Stations),
master/slave units may be used to reduce the potential for receiver cross-talk.
ALLSTAR 831E RECEIVERS ARE INTENDED FOR
USE WITH COMMERCIAL DOOR OPERATORS
ONLY. DO NOT USE FOR ANY OTHER PURPOSE.
DO NOT MODIFY IN ANY MANNER.
CHECK LOCAL BUILDING AND ELECTRICAL
CODES FOR MANDATORY INSTALLATION AND
WIRING REQUIREMENTS.
CONNECT POWER CORDS ONLY TO A PROPERLY
GROUNDED OUTLET. IF PERMANENT WIRING IS
REQUIRED BY CODES, DISCONNECT POWER AT
FUSE BOX OR CIRCUIT BREAKER BEFORE
ATTEMPTING ANY WIRING CONNECTIONS.
DO NOT WEAR RINGS, WATCHES OR LOOSE
CLOTHING WHILE INSTALLING OR SERVICING
GARAGE DOOR OPENERS. WEAR SAFETY
GOGGLES OR OTHER PROTECTIVE EYEWEAR.
AN UNBALANCED DOOR OR ONE THAT STICKS OR
BINDS MAY CAUSE INJURY OR DEATH. ENSURE
DOOR IS PROPERLY BALANCED AND ELIMINATE
ANY STICKING OR BINDING.
YOUR GARAGE DOOR IS A LARGE MOVING
OBJECT. THE SPRINGS, PULLEYS, CABLES AND
MOUNTING HARDWARE UTILIZED TO BALANCE
ITS OPERATION ARE UNDER EXTREME TENSION
AT ALL TIMES AND CAN CAUSE SERIOUS
PERSONAL INJURY, EVEN DEATH, IF DISTURBED.
ONLY A QUALIFIED SERVICE PERSON SHOULD
MOVE, LOOSEN OR ADJUST DOOR SPRINGS OR
HARDWARE.
LOCATE CONTROL PUSHBUTTONS WITHIN SIGHT
OF THE DOOR AND AWAY FROM THE MOVING
PARTS OF THE DOOR. INSTALL ENTRAPMENT
WARNING LABEL NEXT TO THE CONTROL
PUSHBUTTON IN A PROMINENT LOCATION.
REMOVE ALL ROPES AND REMOVE OR MAKE
INOPERATIVE ALL LOCKS CONNECTED TO THE
GARAGE DOOR.
THE IMPORTANT SAFEGUARDS AND
INSTRUCTIONS IN THIS MANUAL CANNOT COVER
ALL POSSIBLE CONDITIONS AND SITUATIONS. IT
MUST BE UNDERSTOOD THAT COMMON SENSE
AND CAUTION MUST BE EXERCISED BY THE
PERSON(S) INSTALLING, MAINTAINING AND
OPERATING THIS EQUIPMENT.
INSTALLER: Leave this manual with your customer upon completion of the installation.
WARNING
TO REDUCE THE RISK OF SEVERE INJURY OR DEATH:
READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS!
PRODUCT FEATURES
IMPORTANT INSTALLATION NOTES