Altinex MT107-303 Switch User Manual


 
MULTITASKER
400-0372-005
2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
MT107-303. Keep this manual handy for future
reference. These safety instructions are to ensure
the long life of your MT107-303 and to prevent fire
and shock hazards. Please read them carefully and
heed all warnings.
1.1 GENERAL
Qualified ALTINEX service personnel or their
authorized representatives must perform all
service.
1.2 INSTALLATION
To prevent fire or shock, do not expose this unit
to water or moisture. Do not place the
MT107-303 in direct sunlight, near heaters, or
heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can
harm internal components.
Handle the MT107-303 carefully. Dropping or
jarring can damage the card.
Do not pull any cables that are attached to the
MT107-303.
Insert the card carefully into the slots of the
MultiTasker without bending any edges.
1.3 CLEANING
Clean only the connector area with a dry cloth.
Never use strong detergents or solvents such as
alcohol or thinner. Do not use a wet cloth or
water to clean the card. Do not clean or touch
any component or PCB.
1.4 FCC NOTICE
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
This equipment has been tested and found to
comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions found herein, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his own expense.
Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could void
the user’s authority to operate the equipment.