Filter
Top Products
INTERFACES
11
CB5100PL-
5BM01005BM
100 ft, 5-BNC M to 5-BNC M
CB5100PL-
5BM01505BM
150 ft, 5-BNC M to 5-BNC M
CB5100PL-
5BM02005BM
200 ft, 5-BNC M to 5-BNC M
CB5100PL-
5BM02505BM
250 ft, 5-BNC M to 5-BNC M
All MS81 series cables listed on the previous page
are 3 ft. long. These are available in 6 ft. and 12 ft.
lengths. Please call 1-714-990-2300 for a wider
selection of cables.
FAQ (FREQUENTLY ASKED QUESTIONS) 9
No: Question Answer
1 Why does
the
termination
switch
have to be
ON?
The termination switch should
be ON if a local monitor is
connected through a straight
cable. It will be OFF only if a
monitor breakout cable is used
at the local monitor output
connector.
2 When and
why should
I use the
Horizontal
Position
Control
dial?
The Horizontal Position
Control dial enables or
disables the control of the
horizontal position of the
image. First, adjust the
horizontal position using the
monitor or projector’s control.
Then use the horizontal
Position Control of the
VA6834FC, if needed.
3 What dip-
switch do I
set to
obtain
composite
SYNC
output?
If the desired output signal is
composite sync, then turn OFF
the H & V OUTPUT Dip-switch
and connect only 4 wires
(RGBS) to the red, green, blue
and sync connectors.
4 When and
why would
I use the
sync on
green dip-
switch,
although
the unit
does not
The VA6834FC does not
separate the sync signal from
green. If the desired output is
in RGsB format, turn the sync
on green dip-switch to the ON
position. The VA6834FC
combines sync on green if the
dip-switch is in the ON
position.
separate
sync from
green?
5 When do I
use the
H & V OUT
dip-switch?
If the desired output is in
RGBHV format, turn ON the H
& V OUT dip-switch. If the H &
V OUT dip-switch is OFF, then
the output signal may have
composite sync present on the
horizontal sync connector.
6 What is a
Common
Computer
Video Card
pin-out?
See table 5 for pin-outs for
common computer video cards
that can be used with the
VA6834FC.