Filter
Top Products
V-MATRIX
5
INSTALLING YOUR VM2142AU 6
Step 1. Slide the VM2142AU and the VM2141AU
into available slots in the V-Matrix™
Enclosure. Make sure that the cards fit
into place. Secure the cards to the V-
Matrix™ by tightening the retainer screws
located on the top and bottom of each
cover plate.
Step 2. Connect audio cables from the audio
source to the input connector of the
VM2141AU. Connect the output
connectors of the VM2142AU to the audio
equipment through an audio cable.
OPERATION 7
The VM2142AU will operate successfully as long
as the card is installed properly and other technical
specifications are followed.
TROUBLESHOOTING GUIDE 8
We have carefully tested and have found no
problems in the supplied VM2142AU; however, we
would like to offer suggestions for the following:
• Make sure that power is connected to the
enclosure and also check to see if the
VM2142AU is pushed in all the way.
• If there is no sound, check the source and
make sure that it is working at an appropriate
volume level and all source connections are
correct.
• Make sure that cables are connected properly.
Also, make sure that the continuity and wiring
are good.
• Make sure that the destination amplifier is
powered. Set the volume of the destination
amplifier to a reasonable level.
• Make sure that the source signal level is high
enough so that the destination amplifier does
not have to provide excessive amplification and
thereby distort the signal.
• If there is problem with the VM2142AU please
call ALTINEX at (714) 990-2300.