Filter
Top Products
V-MATRIX
11
INSTALLING YOUR V-MATRIX™
VIDEO/SYNC
OUTPUT
CARDS 6
Step 1.
Slide the
VM2144VS/ VM2145SS/
VM2146UX
and the
VM2143VS
into
available slots in the V-Matrix™
Enclosure. Make sure that the cards fit
into place. Secure the card to the V-
Matrix™ by tightening the retainer screws
located on the top and bottom of each
cover plate.
Step 2.
Connect an output cable from the signal
source to the input connector of the
VM2143VS
. Connect the output
connector of the
VM2144VS/ VM2145SS/
VM2146UX
to the display devices through
an input cable.
Note:
To set jumpers for
VM2145SS
, see page
6 and 7 for more information. To set
jumpers for
VM2146UX
, see page 8, 9,
and 10.
OPERATION 7
The
VM2144VS/ VM2145SS/ VM2146UX
will
operate successfully as long as the card is installed
properly and other technical specifications are
followed.
TROUBLESHOOTING GUIDE 8
We have carefully tested and have found no
problems in the supplied
VM2144VS/VM2145SS/
VM2146UX
; however, we would like to offer
suggestions for the following:
Make sure that power is connected to the
enclosure and also check to see if the
VM2144VS/
VM2145SS/VM2146UX
is pushed in all the way.
Make sure that you have signal sources connected
to compatible displays.
If the image quality is poor, please make sure that
a high quality of cables is used. We recommend
ALTINEX-made cables for best results.
If there is problem with the
VM2144VS/
VM2145SS/VM2146UX
please call ALTINEX at
(714) 990-2300.