Filter
Top Products
-26-
save
Save your new configuration. Remember that the “save” command is required every
time you make the new configuration.
set default
Return the factory default settings of the WL1100B-AR Wireless LAN Access Router
except for the IP addresses. A 'save' command is required for changes to take effect.
cls
*
Clear the console screen.
exit
*
Exit the console.
?
*
or help
*
Print a help screen.
rz
*
Receive a firmware file by the Zmodem protocol. The console will enter Zmodem
receiving mode and then use the "file upload" function of your terminal emulation
program to upload a new firmware file (ap.img) to the WL1100B-AR Wireless LAN
Access Router. Upon completion, always remember to type the 'reset' command for
running the WL1100B-AR Wireless LAN Access Router with the new firmware.
reset
*
Issue a reset signal. The WL1100B-AR Wireless LAN Access Router will be reset if
user confirms.
3-2-2 Advanced Settings for Security
This section describes the commands to control the security for WL1100B-AR Wireless LAN
Access Router. To prevent unauthorized wireless stations from accessing data transmitted
over the network, the WL1100B-AR Wireless LAN Access Router offers the following levels
of security options.
- Access Control Table restricts wireless stations to access the WL1100B-AR Wireless LAN
Access Router.
- Data Encryption, known as WEP (Wired Equivalency Privacy), encrypts wireless data
transmitted via wireless medium.
Access Control
auth mode | add | del | list| clear
The 'auth' command contains sub-commands that allow you to manage the access control
(MAC address filter) of the WL1100B-AR Wireless LAN Access Router. The access