Filter
Top Products
Chapter 3. Installing a Battery Backup Unit
20 3ware 9690SA SAS/SATA RAID Controller Installation Guide
3 Press down gently until the BBU is seated.
Figure 13. BBU control module connected to the controller
4 Turn the controller over, insert the plastic screw head that you
removed in step 1 into the plastic post, and tighten it gently but
firmly. (Do not over-tighten!)
5 If necessary, attach the extension cable to the BBU control
module in order to reach the intended location of the remote
battery board.
6 Install your 3ware RAID controller. Refer to “Chapter 2.
Installing Your 3ware RAID Controller” on page 11 for details.
Installing the Remote Battery
1 Remove the metal filler brackets for the expansion slot in
which you have decided to install the remote battery board.
Save the screws; they will be used to secure the remote battery
board after you have installed it in the slot.
2 If your enclosure is low-profile, unscrew the full height bracket
from the remote battery board and replace it with the included
low-profile bracket, using the same screws.