Filter
Top Products
Chapter 3. Installing a Battery Backup Unit
25 3ware 9690SA SAS/SATA RAID Controller Installation Guide
c Once the bottom of the module is free, slide the module up
to release the clips on the top.
Figure 17. Removing the battery module
4 Insert the new battery and reattach the battery module to the
remote battery board.
5 If you removed the BBU control module in step 6, reattach it
now.
6 Reinstall the 3ware RAID controller and remote battery board.
7 Reattach the battery cable to the control module
8 Close up your system, and restart it.
9 Run a battery test to compute the estimated battery capacity of
this new battery.
You can run the battery test from the BBU page of either 3BM
or 3DM 2, or by using the 3ware CLI. For detailed instructions,
see the 3ware SAS/SATA RAID Software User Guide or the
3ware SAS/SATA RAID Controller CLI Guide.
1
2
3
2
22 33
3
1
1
1
Bottom clip
a) Push the
battery module
down gently.
b) Lift out the
bottom of the
battery module
to release the
clip on the
bottom edge.
c) Lift up to
remove the clips
on the top edge.