Filter
Top Products
©American Audio® - www.americanaudio.com - WM-16™ Instruction Manual Page 7
WM-16™ LAVALIER OPERATION
1. Plug the receiver in and then switch the power to “On” on the top of the lavalier bodypack.
Note: Make sure the squelch on the receiver is turned the minimum before switching on
the power.
2. Set the receivers channel by following the dipswitch chart below. Set the lavalier to the same
channel as the receiver. The lavalier’s dipswitches are located on the side of the lavalier. If the
signal from the mic is being received by the receiver the Diversity LED’s should light up.
3. Speak, sing, or play your instrument at a typical level. The AF LED’s should icker when receiving
a signal from the lavalier.
4. When nished, press the power to turn OFF the lavalier. Then uplug the power to the receiver.
Receiver Set Up
1. Plug the included power supply into the DC input connector on the back of the receiver.
2. Plug the other end of the power supply into an power outlet.
Note: Make sure the squelch on the receiver is turned the minimum.
Lavalier Set Up
1. Insert two AA batteries into the back battery compartment of the lavalier bodypack.
2. Connect the headset to the bodypack via the attached mini XLR cable. Make sure the Gain con-
trol located on the bottom right side of the bodypack is set to a minimum level.
Connecting the Receiver Output
1. You can connect the receiver to a output source using a cable with an 1/4’’ jack or 3-pin XLR
female connection.
2. Connect one end of the cable to the receiver, and the other end into the mic or line input of a
mixer, PA
system, or amplier. Set the Mic/Line switch accordingly on both the receiver
and lavalier.
WM-16™ LAVALIER SYSTEM SET UP