Filter
Top Products
Wiring Options
14 Three-Phase Rack PDU — Installation and Operation Manual
6. Attach wires to the terminal block as labeled on the board. Tighten
the terminal block screws to secure the wires.
7. Attach a ground wire to the standoff on the metal chassis and
tighten the screw to secure the ground to the chassis.
8. Place the hardwiring access cover (part number 870-70804) on the
PDU, and secure it with one screw in the hole on the top of the
cover.
9. Apply power to the PDU, observing the status LED on the display
interface. If the unit is connected properly, the LED will
illuminate.
Additional power cord
available from APC
You can also use the power cord AP9870, available for purchase from
APC, with the Rack PDUs described in this manual. This power cord
has the following cord ends (IEC 320 C13 to IEC 320 C14):
L1
L1
L2
L2
L3
L3
Metered Rack-Mount PDU Terminal Block