Filter
Top Products
5
I
NSTALLATION
:
1. Install the HCG-400 PSU into either the top or bottom of your case with the four screws provided. Refer to
your case manual if you are unsure where the power supply should be installed.
2. Connect the 24-pin (20 + 4) main power connector to your motherboard. If your motherboard uses a 20-pin
connector, detach the 4-pin attachment on the 24-pin connector.
Note: The detachable 4-pin section cannot be used in place of a 4-pin +12V connector.
3. Connect the 8-pin (4 + 4) connector for the CPU.
Note: Please also refer to your motherboard user’s manual for any special instructions.
4. Connect the 6-pin PCI-E connector to your graphics card (if applicable).
5. Connect all Molex/SATA connector(s) to your hard drives, optical drives (CD/DVD/BluRay™) and other
accessories. Please note that some devices will use either the older 4-pin Molex connectors, while others will
use the newer 15-pin SATA connector. 4-pin Molex connectors have two black wires, a yellow, and a red. The
SATA connector has an additional orange power wire.
6. Connect your floppy drive (if present) using the supplied FDD connector shown in Table 2.
7. When you have all the connections secured, connect the AC power cord to the power supply AC inlet, making
sure the use the heavy-duty cord supplied with your HCG-400.