Filter
Top Products
CHARGING WITH LOGIC SERIES
INTERACTIVE CHARGERS
Charge this battery fully
before using. Allow the battery to reach a
steady green (LifeSaver
®
) mode before using. Charging is automatic on
all Logic Series InterActive chargers. The flashing red and green lights
indicate the charger and battery are establishing communications. The
following are the standard indications on any Logic Series InterActive
Charger (Please refer to the Charger manual for complete charging
instructions):
• Alternating red and green: Evaluating battery and/or
rejuvenating low voltage battery.
• Steady red: Battery waiting to charge (may either be in line to
charge or holding for temperature stabilization).
• Flashing red: Charging.
• Flashing green: Balancing mode or Ready/Verifying. Battery
is typically more the 80% charged.
• Steady green: LifeSaver mode. Batteries will remain 100%
ready for use indefinitely.
The battery should remain on the charger until just prior to being
used. The patented LifeSaver maintenance routine keeps the battery
100% charged and balanced by eliminating the typical self-discharge that
can cripple a battery that is stored for any length of time on the shelf. Do
not remove the HyTRON batteries from the charger more than 8 hours
prior to actual use. For best results, this battery should be returned to the
Logic Series InterActive charger within 48 hours of being used. Please
read the individual charger Owner’s Manual to become acquainted with
the many unique features of the chargers.
6