Filter
Top Products
4
Load the UPS into the Rack and attach the Mounting Brackets
Caution:
The 5000 VA models (without batteries installed) require two people to lift due to its weight.
Attach the Rail Cleat
Attach a mounting cleat to each side of the UPS
using two (2) flat head screws per cleat.
Load the UPS into the Rack
Supporting the UPS from the front and back,
carefully align the cleat with the rails. Slide the
UPS into position.
Attach the Mounting Brackets to the Rack
Use the eight ornamental screws (four per side), to
attach the mounting brackets to the rack post. The
figure displays the placement of four ornamental
screws on the right rack post.
2. Connect Input Power to the UPS
208 Vac Units
1. Connect the UPS line cord (L6-30 plug) into an appropriate electrical outlet.
2. Ensure that all circuit breakers, located on the rear panel, are in the “On” (up) position. The following figure shows
each circuit and its circuit breaker.
ON
ON
ON ON
230 Vac Units with Line Cord
Connect the UPS line cord (IEC-309 plug) into an appropriate electrical outlet.
Screws shown on the right rack post only.
Install four screws on the left rack post as well.