APC BK400EI Power Supply User Manual


 
Page 8
3.0 Installation
3.1 Receiving inspection
Once the UPS has been removed from its shipping container, it should be inspected for
damage that may have occurred while in transit. Immediately notify the carrier and place
of purchase if any damage is found. Two output jumper cords are provided with the UPS.
The packing materials are recyclable. Save for reuse or disposed of them properly.
3.2 Placement
The UPS may be installed in any protected environment. The location should provide
adequate air flow around the unit, in an atmosphere free from excessive dust, corrosive
fumes or conductive contaminants. Do not operate the UPS in an environment where the
ambient temperature or humidity is outside the limits given in the Specifications section
of this manual.
3.3 Load types
The UPS is designed to power all modern computer loads and associated peripheral
devices such as monitors, modems, cartridge tape drives, external floppy drives, etc. The
UPS is not rated to power life support equipment (as described on the rear cover of this
manual).
Caution: The output waveform of this UPS is a sine wave approximation suitable for use
with modern computer power supplies. Other load types may malfunction. In particular,