Filter
Top Products
990-3239A 7/2008
Installation Guide Smart-UPS I/O Hardwire Kit
Safety Information - read these instructions before hardwiring the UPS
Wiring must be performed by qualified electrical personnel.
Adhere to all national and local electrical codes when wiring this unit.
1. Disconnect equipment connected to the UPS.
NOTE: Model 5000RM5U has four internal batteries. The two front batteries must be
disconnected.
2. Press the OFF button located on the front of the UPS.
3. Disconnect batteries from the UPS.
a. Model 5000RM5U has four internal battery modules. The two front internal batteries must
be disconnected.
b. Models 2200/3000XL require the disconnect of one internal battery module. The XL
models may have external batteries connected to the UPS. The external batteries must be
disconnected from the UPS.
c. All other units require the disconnect of one internal battery module.
4. Disconnect the UPS from utility power.
When removing the panels from the UPS, note which cable is connected to the AC
input. There are two 4-pin connectors on the UPS and they are not interchangeable.
APC Worldwide Customer Support
Customer support for this or any other APC product is available at no charge in any of the following
ways:
• Refer to the APC Web site to access documents in the APC Knowledge Base and to submit
customer support requests.
– www.apc.com (Corporate Headquarters)
Connect to localized APC Web sites for specific countries, each of which provides
customer support information.
– www.apc.com/support/
Global support searching APC Knowledge Base and using e-support.
• Contact an APC Customer Support center by telephone or e-mail.
Local, country-specific centers: go to www.apc.com/support/contact for information.
Contact the APC representative or other distributor from whom you purchased your APC product
for information on how to obtain local customer support.
Entire contents copyright 2008 American Power Conversion Corporation. All rights reserved.
Reproduction in whole or in part without permission is prohibited.
APC, the APC logo, and Smart-UPS are trademarks of American Power Conversion Corporation.
All other trademarks, product names, and corporate names are the property of their respective owners and are used for informational purposes only.
Terminal block
Terminal block label
Screws for securing terminal block to UPS
Model 2200/3000 Tower 100/120/230 V
Input and output panels
Blank panel to cover terminal block
Model 2200/3000XL 120/208/230 V
Input panel
Output panel
Blank panel to cover terminal block
Model 5000RM5U 208/230 V
Input and output panels
Blank panel to cover terminal block
2 wire nuts
8 screws for securing
panels to UPS
4 grounding screws
Package Contents