APC UTS6 Power Supply User Manual


 
Operation Manual Universal Transfer Switch UTS6 UTS6H UTS6BI UTS10BI2
Safety and Regulatory Information - save this information
Read the Operation Manual before operating the UTS.
Read, understand, and follow the Safety Precautions in this manual.
Safety Precautions
Adhere to all national and local electrical codes when installing, configuring and operating the UTS.
Installation of the UTS must be performed by a qualified electrician.
Prior to installing the UTS have a qualified electrician check that the wiring in the home or office meets all
local and national electrical codes.
This unit must be connected to a properly grounded utility power source.
Do not install or operate this unit near a source of water or in an environment where the relative humidity
could exceed 95% (non-condensing).
DO NOT operate a generator inside a building. Operating a generator inside a building can cause death by
asphyxiation.
DO NOT allow the total load connected to the UTS to exceed the limits listed in the Specifications section of
the Site Preparation and Installation Guide.
There are no user serviceable components in this unit. Removing the cover from this unit by unqualified
persons can present a shock hazard and may void the warranty.
Periodically inspect all power cords to ensure:
secure connections
proper routing to ensure cords are not pinched, frayed, or stepped on
If the UTS is damaged, disconnect the main circuit breaker and contact APC at www.apc.com.
Warning: Stop using the unit immediately if any of the following conditions arise.
•Conduit or receptacles have been damaged
•Objects have fallen into the unit
•Liquid has spilled into the unit
•The unit has been exposed to rain
•The unit has been dropped or damaged in any way
•The unit does not operate properly
Contact APC at www.apc.com, to arrange service for the unit.