Filter
Top Products
Power Mac G4 SCSI Card -
3
Removing the Installed Card
1. Disconnect the SCSI ribbon cable from the SCSI card.
(Figure 2A)
2 Using a Phillips screwdriver, remove the card’s mounting screw.
(Figure 2B)
3. Gently pull up the card and remove it from the PCI slot.
Figure 2
Power Mac G4 Power Mac G4 (Mirrored Drive Doors)
Installing the Replacement Card
1 Taking care not to touch the gold connector or any of the components on the card,
remove the replacement SCSI card from its static-proof bag and hold it by its corners.
2. Align the card’s connector with the expansion slot and press down until the connector
is inserted all the way into the slot.
• Install the card in the same slot used for the original card.
• Don’t rock the card; instead press it straight into the slot.
• Don’t force the card. If you meet a lot of resistance, pull the card out. Check for
damage or obstructions, and then reinsert the card.
• Pull the card gently to see if it is properly connected. If it stays in place, and if its
gold connectors are barely visible, it is connected.
3. Replace the card’s mounting screw and tighten it to secure the card.
4. Reconnect the SCSI ribbon cable to the card.
A
B