Apple Dual-Slot Riser Card Network Card User Manual


  Open as PDF
of 5
 
Xserve Dual-Slot Riser Card -
5
Installing the Replacement Dual-Slot Riser Card
1. Install the PCI card(s) in the replacement riser card.
2. Reconnect the riser card to the logic board.
3. Tighten the thumbscrew that secures the PCI card fence to the back of the server.
Closing the Server
1. Carefully slide the bottom housing back into the rack.
2. Tighten the front thumbscrews to secure it.
Warning: Never turn on the server unless all of its internal and external parts
are in place and it is closed. Operating the server when it is open or missing
parts can damage it or cause injury.
Apple Computer, Inc.
© 2003 Apple Computer, Inc. All rights reserved.
This document is protected under U.S. Copyright Law and International Treaties, and no
part of this document may be reproduced in any form without written permission from
Apple.
Apple is not responsible for typographical, printing, or inadvertent errors.
Apple Computer, Inc.
1 Infinite Loop
Cupertino, CA 95014-2084
USA
+ 1 408 996 1010
http://www.apple.com
Apple, the Apple logo, Mac, Macintosh, and the Mac logo are trademarks of Apple
Computer, Inc., registered in the U.S. and other countries. Xserve is a trademark of Apple
Computer, Inc.
 previous