Filter
Top Products
Xserve Logic Board -
10
Power Supply
1. Release the locking latch on the power supply cable connector and disconnect the
cable from the drive interconnect board.
(Figure 12)
2. Release the thumbscrew that secures the power supply to the chassis.
Note:
The thumbscrew is captive; you cannot remove it.
3. Grasp the metal flange of the power supply’s connector (on the left side) and lift up to
disconnect the power supply from the logic board.
Note:
You may need to loosen the left side of the power supply and then lift at
another point near the front to disengage it. Do not lift the small lip that contains the
thumbscrew.
4. Holding the power supply in both hands, remove it from the server.
Figure 12