Filter
Top Products
DIP switch settings
In Chapter 2 of the the ImageWriter LQ Owner’s Guide, you’ll find instructions for
changing the DIP switch settings on switch number SW2-8. The DIP switch has been
set to the closed position.With the switch in this position, the printer advances pin-feed
paper far enough so that you can easily tear off the last form. This switch setting also
eliminates the possibility of printing on the previous page or on the platen, when using
applications with no preset top margin.
Ignore the instructions for setting the switch if you want to tear off the last form of your
pin-feed paper, or if your application does not have a preset top margin. If, on the
other hand, you do not want the paper to advance past the top-of-form mark on the
paper guide, use the instructions in the “Changing DIP Switch SW2-8” section of
Chapter 2. Be sure to set the switch to Open.
Cut Sheet Feeder
The optional Cut Sheet Feeder for the ImageWriter LQ has been redesigned. The
ImageWriter LQ Owner’s Guide provides instructions for setting up and installing the
Cut Sheet Feeder on your printer. In these instructions, the manual refers to the
forward collator as a separate piece that you need to install on the feeder. This step is
no longer necessary. The forward collator is no longer a separate piece; it is now a
molded part of the Cut Sheet Feeder itself.
Paper separator
Your ImageWriter LQ Owner’s Guide provides instructions for installing the paper
separator and explains that the separator is necessary only if you use rear-feed paper
paths.
The paper separator now comes installed. Accordingly, you can ignore the installation
instructions. It has also been redesigned to stay in the printer at all times, regardless of
the paper path you choose.
© 1989 Apple Computer, Inc.
Apple, the Apple logo, ImageWriter, and HyperCard are registered trademarks of
Apple Computer, Inc.