Filter
Top Products
4. Lift the lamp module out of the projector. Dispose of the old module in an environmentally responsible manner.
5. Insert the new lamp into the projector, making sure that the connector inside fully engages.
6. Tighten the three screws.
7. Plug the power cord in and turn on the projector.
8. Reset the lamp timer.
Where can I purchase a new lamp?
You can order one from your ASK Proxima dealer/reseller.
How can I maximize my lamp life?
Always allow the projector to completely run through its shutdown cycle before unplugging it. We also recommend cleaning
the dust screens on the lamp module every 200 – 250 hours.
The image disappears or the lamp shuts itself off after a period of time.
1. Make sure the DPMS mode is disabled. The Display Power Management System turns the lamp off after 3 minutes of
not detecting an active source. The projector will return to normal activity immediately if it detects an active source.
After 5 additional minutes, the projector turns completely off. To turn DPMS off, press the Menu button, then
navigate to Setup > System. Verify that DPMS enable is not checked.
2. The projector may be overheating, which is frequently the result of clogged dust filters.
3. Make sure that the projector has the latest system software installed. Version 1.26 included an enhancement that
helps the projector run cooler. Information on how to check the software version and how to download and install
software upgrades is available on the ASK Proxima website.
4. If the problem persists, it is possible that there is an internal problem that requires repair. Take the projector to your
dealer or contact ASK Proxima Technical Support.
Copyright © 1997-2004 InFocus Corporation.
All Rights Reserved.