Filter
Top Products
38
Replacing the projection lamp
The lamp hour timer in the About menu counts the number of hours the
lamp has been in use. When the specified end of the lamp’s life is reached,
the message “Replace lamp” briefly appears on the screen at each startup
and in the Interactive Display. You can order new lamp modules from your
dealer. See “Accessories” on page 41 for information.
1 Turn off the projector and unplug the power cable.
2 Wait 60 minutes to allow the projector to cool thoroughly.
3 Turn the projector upside down and remove the lamp door by removing
the two screws and sliding the lamp door tabs out of the two tab bays.
4 Loosen the three captive screws on the lamp module.
About menu
computer 2
network
audio in
L
computer in
trigger
monitor out
serial control
R
audio in
computer 1
USB
mouse
computer 3
I
O
turn off and unplug
the projector
wait 60 minutes
remove the screws on lamp door
loosen the screws on lamp module