Filter
Top Products
35
Problem: Image is too wide or narrow for screen
•Adjust the zoom or projector placement.
•Adjust the width of the image. See page 23.
Problem: Image is out of focus
•Turn the projection lens to focus the image.
•Make sure the projection screen is at least 4.9 feet (1.5 m) from
the projector, and that the projector is at a 90 degree angle to
the screen.
•Check the projection lens to see if it needs cleaning.
Problem: Projector does not respond to remote control
•Check to see if the batteries in the remote control are viable.
•Check to see if the batteries are inserted properly.
Problem: No sound
•Check the audio input connections.
•Adjust the projector’s or audio source’s volume.
•Verify that the projector’s internal speaker is not set to mute.
Problem: Image and menus are reversed left to right
•Rear projection mode is probably turned on. Turn Rear off in
the System menu. The image should immediately return to
forward projection. See page 24.
Problem: Projected image is distorted
•Try resetting the projector. See page 22.
•Adjust the tuning of the image. See page 23.
Problem: Projected colors don’t match the computer or video
player’s colors
•Just as there are differences in the displays of different moni-
tors, there are often differences between the computer image
and the projected image. Adjust the brightness, color and/or
contrast in the Main menu. See page 23.
Problem: Lamp seems to be getting dimmer
•The lamp begins to lose brightness when it has been in use for
a long time. Replace the lamp as described in “Replacing the
Projection Lamp” on page 30.
M2+.book Page 35 Thursday, April 8, 2004 8:10 AM