Filter
Top Products
3-14
Chapter 3: BIOS setup
Chapter 3
DIGI+ Power Control
CPU Load-Line Calibration [Auto]
Load-line is dened by Intel
®
VRM specication and affects CPU power voltage. The
CPU working voltage will decrease proportionally to CPU loading. Higher load-line
calibration could get higher voltage and good overclocking performance but increases
the CPU and VRM thermal conditions.
Select from Level 1 to Level 8 to adjust CPU power voltage from 0% to 100%.
• The actual performance boost may vary depending on your CPU specication.
• DO NOT remove the thermal module. The thermal conditions must be monitored.
CPU Voltage Frequency [Auto]
Switching frequency affects the VRM transient response and the thermal component
conditions. Higher frequency gets quicker transient response.
Conguration options: [Auto] [Manual]
DO NOT remove the thermal module when setting this item to [Manual]. The thermal
conditions should be monitored.
The following items appear only when you set the CPU Voltage Frequency to [Auto].
VRM Spread Spectrum [Disabled]
Enable the VRM Spread Spectrum to enhance system stability.
Conguration options: [Disabled] [Enabled]
Active Frequency Mode [Disabled]
Enable the Active Frequency Mode for an enhanced power saving
condition.
Conguration options: [Disabled] [Enabled]
The following item appears only when you set the CPU Voltage Frequency to [Manual].
CPU Fixed Frequency [XXX]
This item allows you to set a xed CPU frequency. Use the <+> or <-> keys
to adjust the valinterval.
VCCIN MOS Volt Control [Auto]
This is the driving voltage for the MOSFET on the VCCIN Rail.
Conguration options: [Auto] [Manual] [Active VGD]