Filter
Top Products
28
Chapter 2: Hardware Setup
Install the HDD
1. Insert the HDD into the cage
(label side up) until the holes
on the HDD align with the
holes on the cage.
2. Secure the HDD with four
screws (two on each side).
3. Replace the cage into the
chassis.
Connect the Cables
1. Connect one end of the IDE
cable to the IDE connector at
the back of the drive, matching
the red stripe on the cable with
Pin 1 on the IDE connector.
2. Connect a power cable (plug
marked P5) to the power
connector at the back of the
drive.
3. Connect the other end of the
IDE cable to the primary IDE
connector (blue connector) on
the motherboard.
IDE Cable
Red Stripe to Pin 1
Power Cable (P5)
To primary IDE connector
on the motherboard